Current location: home page > news information > Roots blower information

Talking about the characteristics of stainless steel roots blower, how to select stainless steel roots blower?

Source: Roots blower manufacturer Published on: February 19, 2022 Hits:

Roots blower Debugging should be carried out before work, so as to ensure that accidents will not occur during work. Roots blower has a high speed, and the clearance between rotors and between rotors and machine body is small, so there is less leakage and high volumetric efficiency. The rotor of the blower has been checked for static and dynamic balance. The finished product runs smoothly with minimal vibration.

1. Carefully check whether the screws at each part are fixed or loose.

2. Check whether the oil in the oil tank leaks. Roots blower is mainly composed of the following six parts: motor, air filter, blower body, air chamber, base (also used as oil tank), and oil drip nozzle. The blower operates eccentrically by the rotor offset in the cylinder, and allows the volume change between the blades in the rotor slot to suck in, compress and discharge air. Roots blower is a volume operated blower. When in use, the flow changes little with the change of pressure. However, the flow varies with the speed. Therefore, the selection range of pressure is very wide, and the selection of flow can be achieved by selecting the speed.

3. The circuit is faulty.

Discussion on characteristics of stainless steel roots blower

4. Be able to briefly describe the commissioning of Roots blower before its official operation, and check whether there is significant noise. If there is any targeted treatment.

Difference between stainless steel roots blower and ordinary roots blower:

1. Different prices

Stainless steel roots blowers are expensive. Some roots blowers may be made of stainless steel only with their impellers, while some roots blowers may be made of stainless steel, while some roots blowers may be coated with stainless steel. Therefore, the prices vary widely.

2. Different anti-corrosion capacity

All stainless steel roots blowers have strong anti-corrosion capacity. Due to the development in recent years, the anti-corrosion capacity of stainless steel roots blowers is similar to that of ordinary roots blowers.

Similarities:

3. Same performance

Whether it is a stainless steel roots blower or a common roots blower, there is no difference in performance. It is a positive displacement fan, the pneumatic source of pneumatic conveying!

4. There is little difference in service life

The service life of the two roots blowers is similar. With years of experience, the service life of HD series roots blowers is 10 to 15 years; The failures of roots blowers are mostly caused by unreasonable maintenance. Therefore, we must carry out scientific maintenance after purchasing roots blowers to avoid unscientific operation.

Previous: Requirements and standards for the installation of roots blower, and what should be paid attention to in the installation of roots blower?

Next: Solution to Excessive Clearance of Roots Blower

Back to list