Working principle of Roots blower for electroplating plant:
1. The main ash conveying products basically do not need water. They are transported in a closed way inside the pipeline, which will not pollute the environment and water quality like hydraulic ash removal,
2. At the same time, it can also ensure that the fly ash will not react in the transportation process, maintain the original characteristics of the fly ash, and facilitate the secondary comprehensive utilization of the fly ash and slag.
3. Roots blower has two types of high pressure transmission and low pressure transmission. High pressure transmission is gradually replaced by low pressure transmission due to high cost.
4. Roots blower is suitable for electric ash removal, cement homogenization, silo transfer and transportation of various powdery materials, and is widely used.
5. XQSSR Roots blowers used in the power industry are widely used in the desulfurization of power plants. During the pneumatic transmission of power plants, they will be exposed to corrosive gases such as sulfuric acid, which will corrode the fans.
6. This Roots blower has stable air supply, small flow change, more reasonable impeller engagement with special curve, small leakage, high efficiency and low energy consumption. It is a new energy-saving product.
7. The product adopts high-precision hard tooth surface synchronous gear, with long service life and low noise. In addition, Xinqianshun electric power industry uses Roots blower to effectively protect the body from corrosion by using stainless steel anti-corrosion materials on the surface.
8. The fan impeller adopts the nickel phosphorus plating technology to extend the service life of the impeller and prevent the impeller from being corroded due to contact with corrosive gas, so that the fan cannot operate.
9. XQSSR - Roots blower for power industry is widely used for pneumatic ash conveying and desulfurization in power plants. A large amount of fly ash produced by coal-fired power plants is collected into the ash hopper by the electrostatic precipitator first, and then the ash is put into the transmission pipeline. The power industry uses the compressed air discharged by Roots blower to make the ash flow into the ash silo
Advantages of using Roots blower to transport fly ash in electroplating plant:
1. Roots blower has good sealing performance, no pollution, reliable operation and no pipe blockage, which can effectively improve the operating environment of the power plant.
2. The investment of Roots blower is small, which can replace two bin pumps and reduce the equipment investment.
3. The air pressure of Roots blower is 1000 mmaq --- 8000 mmaq, and the air supply pressure is reduced, which effectively saves the air consumption and greatly reduces the motor power.
4. The amount of post maintenance is small, which saves maintenance costs. After installation, commissioning and operation, only regular inspection is required, and there is almost no maintenance in the later period.
Ordering guide of Roots blower for electroplating plant:
1. Fan specification: caliber, required air volume, pressure rise, etc
2. Transmission medium: dust type and other corrosive gases
3. Equipment requirements: form, cycle number, voltage, single-phase or three-phase
4. Equipment service conditions: indoor or outdoor, ambient temperature
5. Requirements for fan accessories
6. Fan color (with or without specified color
7. Note: the allowable range of specified flow and pressure rise (vacuum degree) is ± 5%
Welcome to purchase Xinqian Shun Fan and put forward valuable suggestions
Address: Chengdong Industrial Park, Zhangqiu District, Jinan, Shandong
Tel.: 0531-83663588
24-hour sales service hotline: 13181700788
Website: //wuhanzhcs.com
