Current location: home page > news information > Roots blower information

Maintenance of Roots blower, simple discussion on solution to water inflow of Roots blower

Source: Roots blower manufacturer Published on: December 21, 2021 Hits:

Generally speaking, Roots blower adopts the most reasonable rotator discharge port structure, so there is little water entering the cavity during operation, but there may be many Roots blowers with water entering during use. This may cause mechanical damage and affect our normal work. Faced with this problem, we have taken a series of protective measures, including the use of strict protective rescue measures, the use of filter screens, mud prevention and so on.

These measures have also taken protective measures for Roots blower to a certain extent, but if the Roots blower is flooded, we will dismantle it for cleaning. Therefore, the removal procedure of Roots blower must be cleaned reasonably. It is not only necessary to dry the internal water, but also some parts. The internal parts of many three blade Luo fans will change when contacting with water, and the internal parts will rust when contacting with water. Therefore, attention must be paid to this in future use.

1. Removal of Roots blower If our manufacturer carries out maintenance, we will remove all the Roots blower. During the removal process, we need to check all the parts and components. The main parts and components to be observed are: gears, impellers, bearings, inside of the casing, etc.

2. Rust removal of Roots blower Roots blower has been used for a long time, the main parts that are easy to rust are the external parts. After the Roots blower enters the water, if it is not cleaned in time, the main parts that are rusted are the impeller, casing and wallboard. If there is a fan with damaged water cooling pipes, the gear and gear box may also be swallowed by rust. Therefore, after determining the fault location, it is necessary to conduct rust removal for other parts.

3. The main cause of locking is that the clearance of Roots blower is too small, which causes friction locking between impeller and impeller, impeller and wallboard. The direct cause may be the damage of impeller and wallboard, and the indirect cause may be the damage of gear, bearing, etc. The locking of Roots blower after water ingress is mostly caused by too small clearance between impellers.

Talking about the solution to water inflow of Roots blower

4. Clearance adjustment and repair After troubleshooting, a very important content is clearance adjustment. Clearance adjustment is very important, which can affect the air volume and pressure of Roots blower. Each clearance must be within the error range.

5. Precautions for maintenance We recommend that you repair the Roots blower nearby and choose a professional repair manufacturer nearby. If you can't repair it nearby, you can only choose to return to the factory for repair. After consulting the repair price, you can consider whether to repair it. Sometimes the repair and transportation costs may be close to that of a new blower. Rust of Roots blower is a common phenomenon, while lock up is a rare phenomenon. There are many reasons for lock up, so it can be found only after troubleshooting.

I believe that after reading the above contents, you should also understand the solution of Roots blower water inflow. I hope it will be helpful to you.

Text label: Roots blower

Article address: //wuhanzhcs.com/html/news/n02/763.html

Previous: Functions of Roots blower lubricating oil on bearings

Next: For the selection of Roots blower, what is the normal range of pressure of Roots blower?

Back to list