Briefly introduce the maintenance of high-pressure water-cooled roots blower (water cooling cycle):

High pressure water-cooled Roots blower In short, it is to reduce the temperature of Roots blower through water circulation to cool it!

Working principle of high-pressure water-cooled roots blower:

High pressure Roots blower is a kind of volumetric fan. There are two three blade impellers rotating relatively in the space sealed by the casing and wall plate. Because each impeller uses involute or the envelope of cycloid as the impeller processing profile, the three blades of each impeller are identical, and the two impellers are identical, which greatly reduces the processing difficulty. Numerical control equipment is used during impeller processing to ensure that no matter where the two impellers are rotated, a certain minimum clearance can be maintained under the condition that the center distance between the two impellers is constant, so as to ensure that the gas leakage is within the allowable range.

How to maintain high-pressure water-cooled Roots blower

In our daily working conditions, the high-pressure water-cooled Roots blower needs to be well maintained according to seasonal changes, and the water-cooling system of the blower needs to be well maintained.

① In the season with high ambient temperature, circulating cooling water is needed to dissipate heat through water cooling, which can reduce the fan temperature to a certain extent, improve the working efficiency of the fan, and extend the service time of the fan.

② In winter with low temperature, if Roots blower does not work, cooling water needs to be discharged to avoid freezing and damaging the blower.

Installation environment and requirements of high-pressure water-cooled roots blower:

① The ambient temperature is generally below 40 ℃, and the relative humidity is below 80%.

② If the transmission medium contains corrosive or flammable gases such as acid and alkali, special design is required to avoid danger.

③ Dust protection, places with a large amount of dust, powder or fiber should be equipped with filters, and the dust attached to the filter screen and the fan should be cleaned regularly.

④ The storage space shall be convenient for routine maintenance and repair, and the installation shall not be too narrow, and vibration shall be avoided. The installation shall be in a place without vibration; If site vibration is unavoidable, damping measures shall be taken.

⑤ The installation site must be installed indoors where is not disturbed by wind and rain.

⑥ Ventilate and dissipate heat. Use it in a well ventilated place, not in an airtight room or airtight box with small space.

The above is what Shandong Xinqianshun Roots blower manufacturer explained to you about the daily maintenance of high-pressure water-cooled Roots blower. I hope it can help you. If you have any questions, please contact us: 0531-83663588