Current location: home page > news information > Roots blower information

How to repair and maintain Roots blower? The manufacturer of Roots blower explains:

Source: Roots blower manufacturer Released on: December 7, 2021 Hits:

Roots blower How to repair and maintain: Roots blower manufacturer teaches you how to repair and maintain Roots blower

Learn about Roots blower first What are the components, Roots blower It is composed of casing and bearing
, gear, impeller, motor, belt and silencer. When Roots blower In case of failure,
To better judge which part of the fan is the problem, Shandong Xinqianshun Roots
The fan manufacturer teaches you how to maintain Roots blower:

1. Before starting the machine, open the manual vent valve and check whether the oil tank and gear oil have reached the position in the oil gauge,
Check whether the fan is flexible by hand. If so, press the start switch to slowly close the vent valve.
So that roots blower can operate under full load (remember not to operate under overload).

2. Regularly arrange staff to check the oil level line. If the gear oil is found to be lower than the center of the oil gauge, it should be timely
Add gear oil. If oil leakage is found at the joint of the oil meter and oil plug, as well as the oil tank and wall panel
Repair and replace in time. Always replace the gear oil half a year.

How to repair and maintain roots blower

3. If high-temperature grease is used for bearings, it shall be supplemented every three months to half a year, and the high-temperature grease shall be replaced every year
grease.

4. Please ensure smooth air circulation in the fan room and perfect cooling measures to ensure that the fan room is clean and avoid
The inlet muffler is blocked or the fan is jammed due to too much dust inhaled by the fan. Must be cleared regularly
Clean the dust in the filter element of the inlet muffler. If it cannot be cleaned or cannot be cleaned, please replace the inlet muffler immediately
filter element.

5. Regularly check and adjust the belt tension, carry out maintenance, and internally check whether the fan bearing and gear are excessive
Degree of wear or damage. Clean the oil tank and sealing device of the fan; Adjust the clearance of the main parts of the fan; Timely discovery
And solve the fan failure to prevent the fan from causing greater damage.

Then when Roots blower does not work or has other problems, it will be returned to the factory for maintenance.

You must be able to disassemble and assemble roots blower, but after disassembly, the fan rotor will be replaced if it is broken
It is necessary to do dynamic balancing, otherwise the clearance will change and you will not be able to repair it. You should return to the factory for repair, which is convenient, fast and worry free.
Welcome to contact Shandong Xinqianshun Roots Blower Factory, a veteran manufacturer with rich technical experience and professional maintenance of Roots Blower,
The service was attentive.