How to maintain the Roots blower after a long time?

How to maintain the Roots blower after a long time? It is very important to learn how to maintain Roots blower after it has been out of service for a long time. Usually, as long as you pay attention to the maintenance of Roots blower, nothing will happen

It is very important to learn how to maintain the Roots blower after it has been out of service for a long time. Usually, as long as you pay attention to the maintenance of the Roots blower, there will be no problems. How to maintain the Roots blower? Here's a brief introduction:

1. Rust stuck

If the Roots blower is idle for a long time, the inside and outside will rust, the iron pillar will fall off in a large area, and the impeller will be stuck. In this case, it will rotate if it needs to be soaked and washed with gasoline, diesel oil and thinner. Turn on the power supply to work normally when the rotation is very loose.

2. Foreign matter is stuck

Large particles enter the Roots blower to block the gap between the parts, causing the Roots blower not to rotate. At this time, it is necessary to carefully remove the foreign matter to avoid particle breakage, and check the gap between the impellers. At the same time, check the cause of foreign matter falling in, so as to avoid falling in again. Turn on the power supply and work normally after it is easy to rotate by hand.

3. Part deformation

Due to long-term non use, the Roots blower parts will have moisture effect reaction, which will cause deformation of the Roots blower parts, but this situation is rare.