One of the common faults of Roots blower, the triangle belt is abnormal

One of the common faults of Roots blower is that the triangle belt is abnormal. As a general air supply equipment, Roots blower of Xinqianshun Machinery Co., Ltd. is widely used in sewage treatment, aquaculture, pneumatic conveying cement, petrochemical, power and other industries. It is mainly used for conveying powdery materials. The clean air of sewage is also mainly from Roots blower, although

As a general air supply equipment, Roots blower of Xinqianshun Machinery Co., Ltd. is widely used in sewage treatment, aquaculture, pneumatic conveying cement, petrochemical, electric power and other industries. It is mainly used for conveying powdery materials. The clean air of sewage also comes from Roots blower. Although it is an auxiliary equipment, it is very important. In case of failure, the whole line will be shut down, so only maintenance quality can be guaranteed, To make it work well.

Today, Xinqianshun Machinery Co., Ltd. talked about the abnormality of triangle belt, one of the common faults of Roots blower.

It is well known that Roots blower is driven by V-belt drive. If the V-belt is worn and dross falls, this situation is caused by the contact between the belt and the bottom of the pulley groove, the two pulley are not parallel or the corresponding groove is not in the same plane, and the pulley is rough. Precautions: when using Roots blower, always check the looseness of the foundation, the tightness of the V-belt, and the use of lubricating oil and grease. If there is any improper adjustment, it should be timely adjusted to avoid the occurrence of downtime and production delay.

Conclusion: This is to remind the readers that due to the limited experience and level of the author, mistakes are inevitable. Please criticize and correct.