Online Message | contact us | chinese | Welcome to the official website of Shandong Xinqianshun Machinery Co., Ltd!
Roots blower manufacturer
National hotline 0531-83663588
Current location: home page > news information > Roots blower information

Five reasons for insufficient air volume of Roots blower _ Roots blower

Source: Roots blower manufacturer Published on: February 24, 2022 Hits:

Cause Roots Blower There are many reasons for insufficient air volume. Under normal operation, if the current of the motor exceeds the rated value, the insufficient air volume may be caused by the valve. The insufficient air volume of Roots blower is mostly caused by impeller or belt problems. Today, I will take you to understand the causes of insufficient air volume of Roots blower.

1、 The filter at the inlet of roots blower is blocked: the silencer at the inlet of roots blower contains a filter, which has the effect of filtering impurities in the air. After a long time, there are too many impurities accumulated inside. If the inlet is blocked, the air volume will be reduced. Therefore, we need to clean the inlet filter regularly to keep the air inlet unblocked.
     

Five reasons for insufficient air volume of Roots blower

2、 Pipe air leakage: Roots blower is a pipe fan, which transports gas through pipes. The damaged pipe gas will naturally cause insufficient air volume when it runs into the air, so the field staff should check in time at ordinary times. If the pipe is damaged or leaked, it should be repaired in time.
3、 Pipe blockage: during the operation of Roots blower, we cannot ensure that the pipe is unblocked at all times. If the pipe is blocked for some reasons, the pressure will increase. At this time, the air volume will be unstable, resulting in the instantaneous air volume being too high or too low. If this situation occurs, we must stop the machine in time to check.
4、 The pipe is too long: if the pipe is too long and the pressure is insufficient, the air volume will also be insufficient. At this time, the pipe needs to be reset.
5、 Belt slippage: no matter how good the quality is, the belt also has a life span. If the time is long, the belt should be replaced in time. Also, the V-belt should be adjusted at intervals during use. If the belt is loose, we regret the slippage or insufficient air flow of the fan.
The above is the reason for the insufficient air volume of Roots blower. I believe you will understand it after reading it. I hope it will help you.