What causes the sudden stop of Roots blower?

What causes the sudden stop of Roots blower? The sudden stop of Roots blower during operation may involve multiple fault causes. Timely maintenance is the key to ensure the normal operation of Roots blower. The following describes some fault causes that may cause Roots blower to stop operation. The following gives you a detailed introduction!

Impeller quality problem:

Possible causes: insufficient machining accuracy, unqualified materials or inaccurate debugging of impellers may lead to mutual adhesion during operation.

Solution: It is necessary to ensure the quality of Roots blower impeller, carry out strict quality inspection test before leaving the factory, and deliver it for use only under normal operation.

Blockage caused by dust and impurities:

Possible cause: long-term transmission of gas containing a large amount of dust and impurities causes these impurities to adhere to the impeller or between the impeller and the blower housing, causing blockage.

Solution: For the conveying gas containing a lot of dust and impurities, an inlet dust filter should be installed at the inlet flange of Roots blower to reduce the adverse impact on Roots blower.

Maintenance is a necessary means to ensure the normal operation of Roots blower. Through reasonable maintenance measures, the sudden stop of Roots blower can be effectively avoided.

The above is the whole content of "What caused the sudden stop of Roots blower?" I hope this article can help you!