Roots Blower After installation, commissioning shall be carried out first to check whether the parts at each part are displaced or loose. The following small editor will share with you what you should pay attention to when debugging Roots blower. 1. Check the fastening of each part and whether the locating pin is loose.
2. Check whether there is oil leakage inside the blower body. There shall be no scaling, rust and scaling inside the engine body.
3. Pay attention to whether the lubrication and heat dissipation are normal, and pay attention to the quality of lubricating oil. Always listen to the blower for noise, pay attention to whether the unit operates under conditions that do not meet the requirements, and add butter regularly.
4. The overload of the blower is sometimes not displayed immediately, so pay attention to the inlet and exhaust pressure. The increasing trend of bearing temperature and motor current can be used to judge whether the machine operates normally. 5. Before disassembling the machine, the matching dimensions of the machine shall be measured and recorded. Mark the parts to ensure that the original matching requirements are maintained after assembly.
6. Oil tank of new machine or overhauled blower shall be cleaned. It is recommended to replace all lubricating oil after 8 hours of operation.
7. The maintenance and overhaul shall be carried out on schedule according to the specific use conditions. And make records. It is recommended to overhaul once a year, and replace bearings and relevant vulnerable parts.
8. It is recommended that the blower be overhauled by professional maintenance personnel.
