Current location: home page > news information > Roots blower information

How to maintain the inlet filter of Roots blower:

Source: Roots blower manufacturer Released on: December 7, 2021 Hits:

After the Roots blower has been used for a period of time, even if it is operated according to the normal operating procedures of Roots blower, the filter screen will still deposit many impurities, increase the pressure of the blower and reduce the flow rate. At this time, the filter should be cleaned in time before continuing to use.

When cleaning the filter, if the filter surface is dirty, it must be washed with water to achieve the effect (note: the filter surface needs to be replaced at this time, and the filter surface cannot achieve the filtering effect after washing). When the filter surface is not dirty, dry clean it on both sides with clean compressed air until no dust particles can be seen by the eyes. If the stainless steel wire of the filter screen is deformed or damaged after cleaning, it should be replaced immediately.

When cleaning impurities, pay attention to the silk screen protection of the filter screen to avoid deformation or damage. Otherwise, the reinstalled filter will not work properly. Clean the air filter once every half month to form the habit of keeping the filter normal, which can avoid unnecessary trouble.

Roots blower tells us that if the distance between the equipment and the fan base is too close, or its stiffness is too small, the same result will be produced. Now that the cause of the fault has been clarified, corresponding measures can be taken to effectively avoid the resonance phenomenon caused by the fan.

Therefore, please check whether the air filter is dirty. If it is dirty, please remove the air filter, unscrew the butterfly nut, remove the cover, clean the filter sponge, and then immerse it in soapy water. Functions of Roots blower lubricant and how to circulate automatically.

After the inspection and analysis of the fan manufacturer, several reliability factors leading to the fan resonance failure were determined. On the one hand, it may be that the cement foundation of the fan is too light, the grouting is poor or the plane size is too small, resulting in the separation of the equipment foundation from the foundation. However, the foundation bolts are loose, the foundation connection is not firm, and the foundation is not rigid enough. On the other hand, it may be related to the stiffness of the fan base or volute; Otherwise, the inlet pipe and outlet pipe connected to the fan may be unsupported and very soft. Caused by association.

How to maintain the filter of Roots blower

1. Clean the air filter once a month. When managing Roots blower filter, if the filter surface is dirty, it must be washed to achieve the effect. (Note: At this time, the filter surface needs to be replaced, and the filtering effect cannot be achieved after the filter surface is washed with water.

2. When the surface of the filter screen is not too dirty, it can be dry cleaned on both sides with clean compressed air, and can be cleaned with eyes in light until no dust can be seen.

3. If the filter is found damaged after cleaning, it should be replaced immediately.

4. When cleaning impurities, pay attention to protecting the filter screen of Roots blower to avoid deformation or damage. Otherwise, the reinstalled filter plate will not work properly.

5. If deformation and damage are found during filter maintenance, we should carry out surface filtering replacement by ourselves.

Word tag: Roots blower

Article address: //wuhanzhcs.com/html/news/n02/835.html

Previous: About the introduction of Roots blower silencer, what is the function of Roots blower silencer?

Next: Three solutions to oil leakage of Roots blower, causes of oil leakage of Roots blower and solutions:

Back to list