1、 Roots Blower After installation, the fan may have some abnormal noise, which will gradually disappear after a period of operation. This is a normal phenomenon. Some new fans may also have unstable current. It is a normal phenomenon, which is caused by the viscosity of lubricating oil. 2. It is ineffective to adjust the gate valve for the air volume of Roots blower. Opening and closing the gate valve will change the pressure of Roots blower.
3. Roots blower cannot be used under overpressure, and it is easy to burn the motor under overpressure. It is necessary to check the pressure of Roots blower every day.
4. The pressure gauge of Roots blower is usually closed. Only open it for measurement when checking the pressure. Do not leave the pressure gauge open for a long time. 5. With regard to noise, the noise of the dedusting Roots blower has always been a concern. The noise values of each blower are different, even for the same model of blower, there are also differences in the noise values, as long as there is no abnormal noise.
6. Generally speaking, if the pressure exceeds 58.8kpa, the Roots blower needs to be cooled by water cooling. Of course, the case of air cooling is not ruled out. If water cooling is used, the temperature of cooling water should not exceed 25 ℃.
7. The water cooled Roots blower RTSR80-RTSSR125 has a water consumption of 5-8L/min, RTSR150-RTSR300 has a water consumption of 8-13L/min. Roots Blower
8. As for the water-cooled Roots blower, the water-cooling pipe shall be started first and the cooling water shall be turned off finally when the Roots blower is shut down.
9. If the roots blower is not used for a long time, the water-cooled roots blower shall drain the water in the water pipe, and the air cooled roots blower shall also clean and protect the inside of the roots blower.
