Current location: home page > news information > Roots blower information

What is the cause of hot hair caused by loud noise of Roots blower? The following four points are for you!

Source: Roots blower manufacturer Published on: 2023-03-07 Hits:

Roots blower In the use process, various unnecessary noises are often reflected by the first-line operation, which affects the use experience and effect of Roots blower, and even causes unnecessary economic losses and loss of reputation.

1、 The placement of Roots blower. In many sites, there is no cement foundation, let alone standard fan pump room. Just put it on the ground and start running. It is easy to cause unevenness under the fan base, which is easy to cause unnecessary vibration. When lowering the fan, if there is no condition, try to place it on a flat and solid ground.

Dense Roots blower

2、 Fixation of Roots blower. When Roots blower leaves the factory, the standard configuration is to match the foundation screws according to the factory base. In the actual use process, I found that many customers did not lay a foundation according to the operating specifications. Roots blowers are subject to vibration inspection when they leave the factory. If there is no foundation, especially high-power Roots blowers, it is easy to generate resonance of varying degrees during use. There is more resonance. Roots blower itself is a device with high noise value, and the noise will become more and more loud. If there is really no condition, the fan base can be fixed on a relatively solid ground by welding diagonal fixing plates to avoid or reduce unnecessary resonance.

Roots blower

3、 Connection problem of Roots blower. The supporting screw connections of Roots blower are standard parts. Ensure that the connection of the fan is on the same horizontal line. In particular, the installation of the silencer should not be staggered as far as possible, which is likely to generate unnecessary blocking pressure. In addition to causing unnecessary noise of the fan, it will also cause the pressure of the fan to be too high, which is likely to cause overheating.

4、 Timely maintenance of Roots blower. Roots blower is connected by belt transmission. Although the balance connection experiment and belt connection experiment are strictly carried out when leaving the factory, the Roots blower needs to be shut down in time on site for various necessary inspections after it has been running stably for about 15-30 days, especially the tightness of the belt. The belt must be carefully checked for looseness, It will cause operating difficulty of Roots blower and unnecessary noise.

Previous: What are the skills for selecting Roots blower in the field of environmental protection?

Next: What are the preparations before starting Roots blower?

Back to list