If the roots blower needs to be treated immediately after water ingress:

Therefore, water seldom enters the cavity during operation, but there are also many three blade roots blowers that have water ingress during use, which has caused mechanical damage and even affected our normal work. In the face of this problem, we have taken a series of protective measures, including the use of strict protective structural measures, the use of filter screens to prevent sludge, and so on,

To some extent, these measures also affect the three leaf roots blower

Generally, the roots blower needs to be treated immediately after water enters. What are the steps to disassemble the three blade roots blower and what should we pay attention to?

Generally, we will use strict protective structural measures for Roots blower, such as filter screen to prevent sludge, and take protective measures for Roots blower. But in case of water ingress into Roots blower, we will dismantle the machine for cleaning, so we must understand the steps of dismantling three leaf Roots blower.

First of all, it is necessary to clean and take out the water reasonably, and also blow dry some parts,

Secondly, many internal parts of three blade roots blowers will change after encountering water, and the internal parts will rust after encountering water, so we must pay attention to this problem in future use.

Moreover, the overload of Roots blower is sometimes not displayed immediately, so pay attention to the changes of inlet and exhaust pressure, bearing temperature and motor current to judge whether the machine operates normally.

If the water quality is good, there is no suspended solids in it, and the water can be drained directly; If there is suspended matter in the water, be sure to clean it, and do not adhere to the impeller and other accessories; Replace lubricating oil, 220 # transparent gear lubricating oil; Check whether the belt is damp If it becomes loose, tighten it; Check whether the motor is damp.