Roots blower is a high-speed machine, so it will produce vibration, and because the pulsation of its internal air also increases the vibration of roots blower, so the roots blower needs to be fixed on the ground during installation.
According to different models of fans, 150 * 150 mm square and 300 mm deep square pits shall be dug on the ground according to the size of the fan, and the anchor bolts shall be embedded. Then the fans shall be connected through bolts and nuts. Finally, the square pits shall be filled with cement concrete. After the concrete is fixed, the nuts shall be tightened with force, so that the fan base and concrete are firmly connected, This can reduce the vibration displacement of roots blower during operation, improve the operation safety of the equipment, and greatly extend the service life of the fan due to reduced vibration.
Roots blower must be installed indoors and will not be disturbed by du wind and rain. For dust protection, if there is a lot of dust, powder or fiber, filters should be installed, and the dirt attached to the filter screen and the fan should be cleaned regularly.
Choose a place with good ventilation and heat dissipation for use, and do not use it in a small space or a closed box. In order to facilitate the maintenance and care of roots blower, it is necessary to avoid the installation place being too narrow and use the blower in a well ventilated place. The protection of roots blower must not be used in an airtight room or airtight box with very small space.
We try to install the roots blower far away from the working and living areas to avoid noise pollution. If we can't avoid installing it around, we need to install a silencer room for the roots blower to reduce the noise generated by the roots blower.
1. It should not be placed in places where people often go in and out to prevent injury and scalding.
2. Do not place places where inflammable, explosive and corrosive gases are likely to occur, so as to prevent fire and poisoning.
3. According to the direction of the air inlet and outlet and the maintenance requirements, there should be appropriate space left near the root surface.
4. When placed outdoors, a rain proof shed should be set to avoid corrosion.
5. It can be used for a long time under the ambient temperature of no more than 40 ℃. When it exceeds 40 ℃, exhaust fan and other cooling methods should be installed to extend the service life of roots blower.
6. When placing, observe whether the foundation is firm, whether the surface is flat, and whether the foundation is higher than the ground.
Precautions:
1. The fan should not be installed in places where people often come in and out to prevent injury and scald.
2. The fan shall not be installed in the place where inflammable, explosive and corrosive gases are easily generated, so as to prevent fire disaster, poisoning and other accidents.
3. According to the direction of the air inlet and outlet and the maintenance needs, there should be adequate space around the foundation surface.
4. When installing the fan, check whether the foundation is firm, whether the surface is flat, and whether the foundation is higher than the ground.
5. When the fan is configured outdoors, a canopy shall be set.
6. The fan can be used for a long time under the ambient temperature of no more than 40 ℃. When the temperature exceeds 40 ℃, exhaust fan and other cooling measures should be installed to improve the service life of the fan.
7. When transporting air, biogas, natural gas and other media, the dust content shall generally not exceed 100mg/m3.
I believe that after reading the above contents, you should also have an understanding of the environment where Roots blower should be installed. I hope it will be helpful to you.
Text term label: Roots blower
Link to this article: //wuhanzhcs.com/html/news/n02/645.html
