The filter screen of Roots blower needs to be cleaned regularly. If the filter device is seriously blocked, the operating power of Roots blower will increase, which will affect the voltage and current of the motor. If the blockage causes overload of the motor, the motor will be easily burned. Therefore, we should regularly clean the filtration device of Roots blower.
When cleaning the filter screen of the silencer at the inlet of Roots blower, if the surface of the filter screen is very dirty, water washing is required to achieve the effect (note: the filter cotton needs to be replaced at this time, and the filter cotton cannot achieve the filtering effect after water washing). When the surface of the filter screen of the silencer at the inlet of Roots blower is not very dirty, clean compressed air can be used to blow on both sides until no dust particles can be seen under the light.
If the stainless steel wire on the filter screen of the fan silencing device is deformed or damaged after cleaning, it needs to be replaced in time. When cleaning impurities, pay attention to the protection of the screen on the filter screen of Roots blower silencer, and no deformation or damage will occur, otherwise the filter screen after reinstallation will not play its due role. Clean the air filter screen once every half month, and develop the habit of maintaining the filter screen correctly at all times to avoid unnecessary trouble.
After the Roots blower has been used for a period of time, even if it is operated according to the normal operating procedures of the Roots blower, the filter screen will still precipitate a lot of impurities, leading to the increase of the pressure of the equipment and the decrease of the flow rate. At this time, the filter screen needs to be cleaned in time before it can continue to be used;
When cleaning the filter screen, if the surface of the filter screen is very dirty, it needs to be washed to achieve the effect (note: the filter cotton needs to be replaced at this time, and the filter cotton cannot achieve the filtering effect after washing).
When the surface of the filter screen is not very dirty, clean compressed air can be used to blow on both sides until no dust particles can be seen from the eye. If the stainless steel wire on the filter screen is deformed or damaged after cleaning, it needs to be replaced in time.
After using the Roots blower for a period of time, the filter screen in the blower will deposit a lot of impurities, which will lead to the increase of the pressure of the equipment and the decrease of the flow rate. At this time, the filter screen needs to be cleaned in time before it can continue to be used. How should the filter screen of high-pressure Roots blower be cleaned?
1. When the surface of the filter screen is not very dirty, clean compressed air can be used to purge on both sides until no dust particles can be seen under the light.
2. If the stainless steel wire on the filter screen is found deformed or damaged after cleaning, it needs to be replaced in time.
3. When cleaning impurities, pay attention to the protection of the screen on the filter screen to avoid deformation and damage, otherwise the reinstalled filter screen will not play its due role.
4. When cleaning the filter screen, if the surface of the filter screen is very dirty, it needs to be washed to achieve the effect (note: the filter cotton needs to be replaced at this time, and the filter cotton cannot achieve the filtering effect after washing).
5. Clean the air filter screen once every half month, and form the correct habit of maintaining the filter screen at all times to avoid unnecessary trouble.
I believe that after reading the above content, you should also have an understanding of the problems that need to be noticed when cleaning the filter screen of Roots blower. I hope it will be helpful to you.
Text label: Roots blower
Link to this article: //wuhanzhcs.com/html/news/n02/702.html
