Current location: home page > news information > Roots blower information

How to solve the blockage of inlet filter screen of Roots blower?

Source: Roots blower manufacturer Published on: December 9, 2021-12 Hits:

After the Roots blower has been used for a period of time, even if it is operated according to the normal operating procedures of Roots blower, the filter screen will still deposit many impurities, increase the pressure of the blower and reduce the flow rate. At this time, the filter should be cleaned in time before continuing to use.

How to solve the blockage of inlet filter screen of Roots blower

When cleaning the filter, if the filter surface is dirty, it must be washed with water to achieve the effect (note: the filter surface needs to be replaced at this time, and the filter surface cannot achieve the filtering effect after washing). When the filter surface is not dirty, dry clean it on both sides with clean compressed air until no dust particles can be seen by the eyes. If the stainless steel wire of the filter screen is deformed or damaged after cleaning, it should be replaced immediately. When cleaning impurities, pay attention to the silk screen protection of the filter screen to avoid deformation or damage. Otherwise, the reinstalled filter will not work properly. Clean the air filter once every half month to form the habit of keeping the filter normal, which can avoid unnecessary trouble.

Maintenance method for intake filter of Roots blower:

1. Clean the air filter once a month. When maintaining the filter, if the surface is dirty, it needs to be cleaned to achieve the effect. At this time, the filter cotton needs to be replaced. After cleaning, the filter cotton cannot achieve the filtering effect.

2. When the surface of the filter screen is not very dirty, clean compressed air can be used to blow to both sides until no dust particles can be seen under the light.

3. If the filter disk is damaged after cleaning, it needs to be replaced in time.

4. When cleaning impurities, pay attention to protecting the filter screen of Roots blower, and do not deform or damage it, otherwise the reinstalled filter disk will not play its due role.

5. If the filter screen is deformed or damaged during maintenance, we need to replace the filter cotton by ourselves.

Cleaning method of roots blower filter:

1. When the surface of the filter is not dirty, clean compressed air can be used to make a double eye blow to wash the face until no dust can be seen in the light.

2. It is found that the stainless steel on the filter screen is deformed or damaged after cleaning. If it is a bad phenomenon, it should be replaced in time.

3. When cleaning impurities, please note that the screen saver of the filter grid may be deformed and damaged. Otherwise, the filter will not play its due role after reinstallation.

4. If the filter surface is dirty when cleaning the filter. If waiting, the effect can be achieved only after water washing (note: the cotton filter needs to be replaced at this time, and the filter cotton cannot achieve the filtering effect after water washing).

5. Clean the air filter screen once every half month, and always cultivate the habit of protecting the filter screen with correct dimensions to avoid unnecessary trouble.

I believe that after reading the above, you should also know how to maintain the filter of Roots blower. I hope it will help you.

Text label: Roots blower

Article address: //wuhanzhcs.com/html/news/n02/825.html

Previous: What should be paid attention to during installation of Roots blower during maintenance:

Next: Understand the function and use of Roots blower silencer

Back to list