How to solve Roots blower Common faults of? What are the tips to prevent the blower motor from burning out? This is what I want to introduce to you today. I hope you can help you solve the common faults of Roots blower through this introduction 1. Roots blower is applicable to continuous working system and allows forward and reverse operation.
2. When the output shaft and input shaft of the unloader are equipped with other parts, direct hammering is not allowed to prevent damage.
3. During transportation and installation of Roots blower, it shall be kept stable and avoid collision, which may cause shell fracture and deformation. Roots blower is a volumetric blower. When in use, the flow changes little with the change of pressure. However, the flow varies with the speed. Therefore, the selection range of pressure is very wide, and the selection of flow can be achieved by selecting the speed.
4. During operation, avoid overloading of equipment due to large particles of materials and strong adhesive force, or equipment jamming or motor short circuit caused by foreign matters left in the dust remover, and suggest users to bolt and install overload protection devices in time. Roots blower is a volumetric blower. When in use, the flow changes little with the change of pressure. However, the flow varies with the speed. Therefore, the selection range of pressure is very wide, and the selection of flow can be achieved by selecting the speed. 5. In the process of use, if the equipment has axial air leakage, ash leakage and other phenomena, the pressing cover can be firm.
6. Before leaving the factory, the reducer of Roots blower has been fully filled with lubricating oil # 00 grease, and the ash discharge valve has been fully filled with lithium base grease. Within 6-10 months after being put into use, the transmission and bearing parts should be supplemented or replaced with grease. If the ambient temperature is high, damp or there is too much dust in the air, how to solve the common fault of Roots blower should shorten the oil change time appropriately.
Methods to prevent blower motor from burning out
1. The blower shall be properly selected, and the amount of material to be discharged shall not be greater than the amount of material to be discharged by the blower itself, so as to avoid excessive pressure, which may cause the motor to burn out.
2. The viscosity of the material should not be too high, which can prevent the blower motor from burning out in a short time.
3. The motor connector of the air lock valve of the blower shall not be false to avoid burning.
4. The working time is not easy to be too long to avoid burning. The rotating speed of the blower of the rotary fan is high, and the clearance between the rotor and the rotor, and between the rotor and the body is small, so there is less leakage and high volumetric efficiency. Rotors of Roots blower are subject to static and dynamic balance verification. The finished product runs smoothly with minimal vibration.
5. The ventilation effect around the blower must be good. If the heat dissipation is poor, the motor is easy to burn out. 6. The surrounding environment of the blower should be cleaned up. If it is too dirty, the heat dissipation efficiency of the motor radiator will be reduced, resulting in burning.
